Publications in collaboration with researchers from Instituto de Cerámica y Vidrio (21)

2024

  1. Cost-effective synthesis of stable CoxC@few-layered graphene nanostructures embedded in a carbon matrix

    Journal of Alloys and Compounds, Vol. 995

  2. Modulating the magnetic properties of Fe3C/C encapsulated core/shell nanoparticles for potential prospects in biomedicine

    Materials Today Chemistry, Vol. 39

2023

  1. Erratum: A feasible pathway to stabilize monoclinic and tetragonal phase coexistence in barium titanate-based ceramics (J. Mater. Chem. C (2022) 10 (17743–17756) DOI: 10.1039/D2TC04265G)

    Journal of Materials Chemistry C

  2. Generation of Defective Few-Layered Graphene Mesostructures by High-Energy Ball Milling and Their Combination with FeSiCuNbB Microwires for Reinforcing Microwave Absorbing Properties

    ACS Applied Materials and Interfaces, Vol. 15, Núm. 2, pp. 3507-3521

  3. Implementing a sol-gel route to adjust the structural and dielectric characteristics of Bi and Fe co-doped BaTiO3 ceramics

    Inorganic Chemistry Communications, Vol. 147

  4. Optimization of multilayer graphene-based gas sensors by ultraviolet photoactivation

    Applied Surface Science, Vol. 610

  5. Sol-gel synthesis control of iron-cobalt alloy/ferrite core/shell nanoparticles supported by a carbon medium with semi-hard magnetic features

    Journal of Alloys and Compounds, Vol. 959

  6. Spectroscopic properties, conduction processes and the Summerfield scaling of barium titanate ceramics based on Bi and Fe

    Inorganic Chemistry Communications, Vol. 157

2022

  1. A feasible pathway to stabilize monoclinic and tetragonal phase coexistence in barium titanate-based ceramics

    Journal of Materials Chemistry C, Vol. 10, Núm. 46, pp. 17743-17756

  2. Novel one-pot sol-gel synthesis route of Fe3C/few-layered graphene core/shell nanoparticles embedded in a carbon matrix

    Journal of Alloys and Compounds, Vol. 902

2021

  1. Boosting the coercivity of SrFe12O19nanocrystalline powders obtained using the citrate combustion synthesis method

    Journal of Physics D: Applied Physics, Vol. 54, Núm. 1

  2. Multiphase materials based on the Fe73.9Si15.5Cu1Nb3B6.6 alloy obtained by dry and wet high-energy ball milling processes

    Journal of Alloys and Compounds, Vol. 864

  3. Ultrasensitive NO2 gas sensor with insignificant NH3-interference based on a few-layered mesoporous graphene

    Sensors and Actuators, B: Chemical, Vol. 335

2020

  1. Control of the Length of Fe73.5Si13.5Nb3Cu1B9 Microwires to Be Used for Magnetic and Microwave Absorbing Purposes

    ACS applied materials & interfaces, Vol. 12, Núm. 13, pp. 15644-15656

  2. Further progress in the study of epsilon iron oxide in archaeological baked clays

    Physics of the Earth and Planetary Interiors, Vol. 307

  3. Ultrafast particle size reduction of Fe73.9Si15.5Cu1Nb3B6.6 by high-energy milling: Nb2O5 as a marker of permeability enhancement and magnetic hardening

    ACS Applied Electronic Materials, Vol. 2, Núm. 5, pp. 1484-1496

2019

  1. Self-assembly of iron oxide precursor micelles driven by magnetic stirring time in sol-gel coatings

    RSC Advances, Vol. 9, Núm. 31, pp. 17571-17580

2018

  1. Exchange-spring behavior below the exchange length in hard-soft bilayers in multidomain configurations

    Physical Review B, Vol. 98, Núm. 21

2017

  1. Measurement of the magnetic permeability of amorphous magnetic microwires by using their antenna resonance

    Review of Scientific Instruments, Vol. 88, Núm. 12

  2. Tuning Metamaterials by using Amorphous Magnetic Microwires

    Scientific Reports, Vol. 7, Núm. 1