Publikationen in Zusammenarbeit mit Forschern von Instituto de Magnetismo Aplicado (26)

2024

  1. A novel methodology for designing Mono/Bi-slab X-band microwave absorbers of Carbon-Powder composites

    Materials and Design, Vol. 238

  2. Eco-Friendly Sol–Gel Coatings with Organic Corrosion Inhibitors for Lightweight AZ61 Alloy

    Gels, Vol. 10, Núm. 3

2023

  1. Erratum: A feasible pathway to stabilize monoclinic and tetragonal phase coexistence in barium titanate-based ceramics (J. Mater. Chem. C (2022) 10 (17743–17756) DOI: 10.1039/D2TC04265G)

    Journal of Materials Chemistry C

  2. Implementing a sol-gel route to adjust the structural and dielectric characteristics of Bi and Fe co-doped BaTiO3 ceramics

    Inorganic Chemistry Communications, Vol. 147

  3. Optimization of multilayer graphene-based gas sensors by ultraviolet photoactivation

    Applied Surface Science, Vol. 610

  4. Sol-gel synthesis control of iron-cobalt alloy/ferrite core/shell nanoparticles supported by a carbon medium with semi-hard magnetic features

    Journal of Alloys and Compounds, Vol. 959

  5. Spectroscopic properties, conduction processes and the Summerfield scaling of barium titanate ceramics based on Bi and Fe

    Inorganic Chemistry Communications, Vol. 157

2022

  1. A combined micro-Raman, X-ray absorption and magnetic study to follow the glycerol-assisted growth of epsilon-iron oxide sol-gel coatings

    Journal of Alloys and Compounds, Vol. 892

  2. A feasible pathway to stabilize monoclinic and tetragonal phase coexistence in barium titanate-based ceramics

    Journal of Materials Chemistry C, Vol. 10, Núm. 46, pp. 17743-17756

  3. Effect of organic solvent on the cold sintering processing of SrFe12O19 platelet-based permanent magnets

    Journal of the European Ceramic Society, Vol. 42, Núm. 3, pp. 1014-1022

  4. Generation of Defective Few-Layered Graphene Mesostructures by High-Energy Ball Milling and Their Combination with FeSiCuNbB Microwires for Reinforcing Microwave Absorbing Properties

    ACS Applied Materials and Interfaces

  5. Large Two-Magnon Raman Hysteresis Observed in a Magnetically Uncompensated Hematite Coating across the Morin Transition

    Coatings, Vol. 12, Núm. 4

  6. Novel one-pot sol-gel synthesis route of Fe3C/few-layered graphene core/shell nanoparticles embedded in a carbon matrix

    Journal of Alloys and Compounds, Vol. 902

2021

  1. Boosting the coercivity of SrFe12O19nanocrystalline powders obtained using the citrate combustion synthesis method

    Journal of Physics D: Applied Physics, Vol. 54, Núm. 1

  2. Boosting the tunable microwave scattering signature of sensing array platforms consisting of amorphous ferromagnetic fe2.25 co72.75 si10 b15 microwires and its amplification by intercalating cu microwires

    Nanomaterials, Vol. 11, Núm. 4

  3. Hexaferrite-based permanent magnets with upper magnetic properties by cold sintering process via a non-aqueous solvent

    Acta Materialia, Vol. 219

  4. Multiphase materials based on the Fe73.9Si15.5Cu1Nb3B6.6 alloy obtained by dry and wet high-energy ball milling processes

    Journal of Alloys and Compounds, Vol. 864

  5. Ultrasensitive NO2 gas sensor with insignificant NH3-interference based on a few-layered mesoporous graphene

    Sensors and Actuators, B: Chemical, Vol. 335

2020

  1. Control of the Length of Fe73.5Si13.5Nb3Cu1B9 Microwires to Be Used for Magnetic and Microwave Absorbing Purposes

    ACS applied materials & interfaces, Vol. 12, Núm. 13, pp. 15644-15656

  2. Further progress in the study of epsilon iron oxide in archaeological baked clays

    Physics of the Earth and Planetary Interiors, Vol. 307