Publicaciones en colaboración con investigadores/as de Universidad Carlos III de Madrid (77)

2024

  1. Influence of the biomechanical evaluation of rupture using two shapes of same intramedullary implant after proximal interphalangeal joint arthrodesis to correct the claw/hammer pathology: A finite element study

    International Wound Journal, Vol. 21, Núm. 8

  2. Reliability and Validity of the Orthotic Deformation Test

    Applied Sciences (Switzerland), Vol. 14, Núm. 18

2023

  1. A Review of Wireless Charging Systems for Cardiac Pacemakers

    CPE-POWERENG 2023 - 17th IEEE International Conference on Compatibility, Power Electronics and Power Engineering

  2. Coupling and Load Estimation with Current and Voltage Primary Sensing in Free Communication Wireless Power Charging

    IECON Proceedings (Industrial Electronics Conference)

  3. Digital Control for a Modular System of DC/DC Converters for Primary Distribution System

    2023 13th European Space Power Conference, ESPC 2023

2022

  1. Extension of the Injected-Absorbed-Current Method Applied to DC-DC Converters With Input Filter, Output Postfilter, and Feedforward Compensations

    IEEE Transactions on Transportation Electrification, Vol. 8, Núm. 1, pp. 856-874

  2. Innovation, Research and Development in Engineering Education. Activities of the Spanish Chapter of the IEEE Education Society: Directive Board of the IEEE Education Society Spanish Chapter 2020-2021

    15th International Conference of Technology, Learning and Teaching of Electronics, TAEE 2022 - Proceedings

  3. Modeling of Dual Active Half Bridge (DAHB) converter based on discrete time techniques

    Proceedings of the IEEE Workshop on Computers in Power Electronics, COMPEL

  4. Polymer Optical Fiber Plantar Pressure Sensors: Design and Validation

    Sensors, Vol. 22, Núm. 10

2021

  1. Automatic determination of the amplitude of the perturbation signal for the non-parametric identification of DC/DC switching converters

    2021 IEEE 22nd Workshop on Control and Modelling of Power Electronics, COMPEL 2021

  2. Comparison of different large signal measurement setups for high frequency inductors

    Electronics (Switzerland), Vol. 10, Núm. 6, pp. 1-14

  3. Comprehensive Design Procedure for Racetrack Microinductors

    IEEE Journal of Emerging and Selected Topics in Power Electronics, Vol. 9, Núm. 6, pp. 6912-6923

  4. Control strategies analysis used in power distribution systems of electric vehicles with multiple energy sources

    2021 IEEE 15th International Conference on Compatibility, Power Electronics and Power Engineering, CPE-POWERENG 2021

  5. Design and Implementation of Two Hybrid High Frequency DPWMs Using Delay Blocks on FPGAs

    IEEE Transactions on Power Electronics, Vol. 36, Núm. 12, pp. 14567-14578

  6. Discrete-time modeling of pulsewidth modulated DC-DC converters in subsampling conditions

    IEEE Journal of Emerging and Selected Topics in Power Electronics, Vol. 9, Núm. 5, pp. 5962-5974

  7. Gender and STEAM as part of the MOOC STEAM4ALL

    IEEE Global Engineering Education Conference, EDUCON

  8. LQG digital state-feedback control of a Dual-Active-Bridge Series-Resonant Converter

    Proceedings of the IEEE International Conference on Industrial Technology

  9. Nonparametric frequency response identification for dc-dc converters based on spectral analysis with automatic determination of the perturbation amplitude

    Sensors, Vol. 21, Núm. 9

2020

  1. DC/DC Converter Output Capacitor characterization using identification techniques and DTW

    Conference Proceedings - IEEE Applied Power Electronics Conference and Exposition - APEC

  2. Design of DPWM with high resolution under 80 ps using low-cost Xilinx FPGA

    Conference Proceedings - IEEE Applied Power Electronics Conference and Exposition - APEC