Publicaciones en las que colabora con David Marrero López (43)

2011

  1. Electrochemical performance of nanostructured La0.6Sr 0.4CoO3-δ and Sm0.5Sr 0.5CoO3-δ cathodes for IT-SOFCs

    Journal of Power Sources, Vol. 196, Núm. 22, pp. 9276-9283

  2. Influence of phase segregation on the bulk and grain boundary conductivity of LSGM electrolytes

    Solid State Ionics, Vol. 186, Núm. 1, pp. 44-52

  3. Lanthanum germanate-based apatites as electrolyte for SOFCs

    Fuel Cells, Vol. 11, Núm. 1, pp. 65-74

  4. Microstructure and conductivity of La1-xSrxGa 0.8Mg0.2O3-λ electrolytes prepared using the freeze-drying method

    Journal of the American Ceramic Society, Vol. 94, Núm. 4, pp. 1031-1039

  5. Pilas de combustible de Membrana polimérica

    Afinidad: Revista de química teórica y aplicada, Vol. 68, Núm. 554, pp. 246-258

2010

  1. Effect of a CGO buffer layer on the performance of (La0.6Sr0.4)0.995Co0.2Fe0.8O3-ä cathode in YSZ-Based SOFC

    Boletín de la Sociedad Española de Cerámica y Vidrio, Vol. 49, Núm. 1, pp. 15-22

  2. Evaluation of apatite silicates as solid oxide fuel cell electrolytes

    Journal of Power Sources, Vol. 195, Núm. 9, pp. 2496-2506

  3. Fabrication of 3D carbon microstructures using glassy carbon microspheres and organic precursors

    Carbon, Vol. 48, Núm. 13, pp. 3964-3967

  4. Performance of a novel type of electrolyte-supported solid oxide fuel cell with honeycomb structure

    Journal of Power Sources, Vol. 195, Núm. 2, pp. 516-521

  5. Redox behaviour, chemical compatibility and electrochemical performance of Sr2MgMoO6 - δ as SOFC anode

    Solid State Ionics, Vol. 180, Núm. 40, pp. 1672-1682

2009

  1. Cost-effective microstructural engineering of solid oxide fuel cell components for planar and tubular designs

    Journal of the American Ceramic Society, Vol. 92, Núm. 1, pp. 276-279

  2. High temperature phase transition in SOFC anodes based on Sr2MgMoO6-δ

    Journal of Solid State Chemistry, Vol. 182, Núm. 5, pp. 1027-1034

  3. Novel procedures for the microstructural design of SOFC materials

    ECS Transactions

  4. On Ba0.5Sr0.5Co1-yFeyO3-δ (y = 0.1-0.9) oxides as cathode materials for La0.9Sr0.1Ga0.8Mg0.2O2.85 based IT-SOFCs

    International Journal of Hydrogen Energy, Vol. 34, Núm. 23, pp. 9486-9495

  5. Structural and electrochemical characterisation of Pr0.7Ca0.3Cr1-yMnyO3-δ as symmetrical solid oxide fuel cell electrodes

    Journal of Power Sources, Vol. 188, Núm. 1, pp. 230-237

  6. Synthesis and characterisation of BaCeO3-based proton conductors obtained from freeze-dried precursors

    Journal of the European Ceramic Society, Vol. 29, Núm. 1, pp. 131-138

2008

  1. An all-in-one flourite-based symmetrical solid oxide fuel cell

    Journal of Power Sources, Vol. 177, Núm. 1, pp. 154-160

  2. Determination of the ionic transport numbers of lanthanum gallate materials by impedance spectroscopy and modified EMF method

    Boletín de la Sociedad Española de Cerámica y Vidrio, Vol. 47, Núm. 3, pp. 153-158

  3. Effect of phase transition on high-temperature electrical properties of GdBaCo2O5 + x layered perovskite

    Solid State Ionics, Vol. 179, Núm. 17-18, pp. 611-618

  4. Evaluation of GdBaCo2O5 + δ as cathode material for doped lanthanum gallate electrolyte IT-SOFCs

    Fuel Cells, Vol. 8, Núm. 5, pp. 351-359