Publications en collaboration avec des chercheurs de Czech Technical University in Prague (14)

2024

  1. Atomically Precise Control of Topological State Hybridization in Conjugated Polymers

    ACS Nano

2021

  1. Effect of substrate bias voltage on the mechanical properties and deformation mechanisms in the nanostructured Ti-22Nb-10Zr coating

    Surface and Coatings Technology, Vol. 405

  2. Evaluation of bias voltage-dependent mechanical properties of amorphous TiSi2 thin films on PEEK by nano-characterization techniques

    Surface and Coatings Technology, Vol. 409

2019

  1. Deformation-Controlled Design of Metallic Nanocomposites

    ACS Applied Materials and Interfaces, Vol. 11, Núm. 49, pp. 46296-46302

  2. The role of α″ orthorhombic phase content on the tenacity and fracture toughness behavior of Ti-22Nb-10Zr coating used in the design of long-term medical implants

    Applied Surface Science, Vol. 464, pp. 328-336

2018

  1. Development of new β/α″-Ti-Nb-Zr biocompatible coating with low Young's modulus and high toughness for medical applications

    Materials and Design, Vol. 142, pp. 44-55

2017

  1. Assessment of mechanical behavior of PLA composites reinforced with Mg micro-particles through depth-sensing indentations analysis

    Journal of the Mechanical Behavior of Biomedical Materials, Vol. 65, pp. 781-790

2016

  1. Nanomechanical characterization of alumina coatings grown on FeCrAl alloy by thermal oxidation

    Journal of the Mechanical Behavior of Biomedical Materials, Vol. 57, pp. 310-320

  2. Repetitive nano-impact tests as a new tool to measure fracture toughness in brittle materials

    Journal of the European Ceramic Society, Vol. 36, Núm. 13, pp. 3235-3243

2015

  1. Dynamic nanomechanical properties of novel Si-rich intermetallic coatings growth on a medical 316 LVM steel by hot dipping in a hypereutectic Al-25Si alloy

    Journal of the Mechanical Behavior of Biomedical Materials, Vol. 46, pp. 93-103

  2. Length-scale-dependent mechanical behaviour of Zr/Nb multilayers as a function of individual layer thickness

    Materials Science and Engineering: A, Vol. 632, pp. 137-146

2014

  1. Effects of bath composition and processing conditions on the microstructure and mechanical properties of coatings developed on 316 LVM by hot dipping in melted AlSi alloys

    Journal of Alloys and Compounds, Vol. 617, pp. 646-653

  2. Microstructure and mechanical properties of physical vapor deposited Cu/W nanoscale multilayers: Influence of layer thickness and temperature

    Thin Solid Films

  3. Strain rate effect on semi-crystalline PLLA mechanical properties measured by instrumented indentation tests

    European Polymer Journal, Vol. 59, pp. 239-246